Specification as installed
The installation of six individual split -type units be installed to meet clients stringent requirements in addition to a custom BMS controlled panel to facilitate fault monitoring and temperature monitoring.
Originally there were two larger multi-split VRF type systems installed feeding two individual ceiling mount units within the lift motor rooms (per unit). Our proposal was to have four ceiling mount units located within the same zones as the original units and two further wall mount units located at either side for out of hours redundancy and back up.
New Installations
• The installation of flexi-foot style mounting frame. (units to be placed on floor tiles)
• Installation of power supply to taken from boards within lift motor enclosure (3-Phase)/(single phase) localised isolator to be installed to the side of each unit.
• The installation of six Mitsubishi units 2 pipe cooling only
• The installation of new copper pipe runs and cabling runs to the matching indoor unit via Pipe/cable tray agreed route (all pipework to be lagged and tied)
• The installation of six Indoor units to suit sizing specification at present.
• New style controllers to be fitted one per unit location. Model: PAR 32MA . New condensate to run via existing drainage network. Gravity fed.
• Full commissioning to be included as standard.
• Follow up leak check to also be included.
Additions
* Small reach towers ladders and access equipment.
* Floor covering and site clearance.
* Two custom cut box covers to protect lift motor windings (PVC ST) * Multiple engineers to complete works within a short timeframe.
* Control setup to meet clients prior requirement.
( PROJECT VALUE 60K + )